Panasonic KX-NS1000 - Page 54

If a call on hold is not retrieved within a preprogrammed time period, the Hold Recall tone is heard at the
extension which put the call on hold. If the extension is engaged in a call, the Hold Alarm will be heard.
• If
an outside party is placed on hold and the call is not retrieved within a preprogrammed time period after
the Hold Recall time expires, the call is automatically disconnected.
• Automatic Call Hold
A PT can be configured through system programming to place the current call on hold when the PT user
presses a CO, ICD Group, INTERCOM or PDN button to make or answer another call. If this feature is not
enabled, the current call will be disconnected.
[Example of Automatic Call Hold]
It is possible to receive an incoming CO line call by pressing the flashing ICD Group button. The current
intercom call (on the INTERCOM button) is placed on hold. To return to the held call, press the INTERCOM
button.
• Call Hold Retrieve Deny
Internal Call Block (® 10.1.15 Internal Call Block) also determines which extensions’ calls an extension
user can retrieve, i.e., if extension 101 cannot call extension 201, then it cannot retrieve extension 201’s
held calls either.
• SLT Hold Mode
It is possible to choose how to hold and transfer a call with an SLT through system programming. The
following methods are available:
Hold
Hold
(to be Retrieved from
Another Extension)
*1
Transfer to CO
Line
Transfer to
Extension
Mode 1
Flashing the
hookswitch
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
CO Line Access
No.
Flashing the
hookswitch
+
Extension No.
Mode 2
(Default)
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
CO Line Access
No.
Flashing the
hookswitch
+
Extension No.
Mode 3
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Hold Feature No.
+
CO Line Access
No.
Flashing the
hookswitch
+
Extension No.
Mode 4
Flashing the
hookswitch
+
Hold Feature No.
+
Going on-hook
Flashing the hookswitch
+
Hold Feature No.
+
Hold Feature No.
+
Going on-hook
Flashing the
hookswitch
+
Hold Feature No.
+
CO Line Access
No.
Flashing the
hookswitch
+
Hold Feature No.
+
Extension No.
*1
These operations must be performed when the held call is intended to be retrieved from another extension using the holding
extension number.
If one of the following occurs frequently with an SLT, choose
"Mode 2", "Mode 3", or "Mode 4":
54 Feature Manual Document Version 2016-03
4.1.4 Call Hold