If an extension number is required when changing any PS settings while in Wireless XDP Parallel mode,
use the original extension number assigned to the PS, not the extension number of the paired
(wired)
telephone.
• If the Extension Feature Clear is performed, the corresponding extension data for both the wired telephone
and the PS will be cleared. (® 6.1.9 Extension Feature Clear)
• When a call arrives, both the wired telephone and the PS will ring. However, when one of the following
settings is made, only the telephone which was used to make the setting will ring.
– Automatic Callback Busy (® 2.1.4 Automatic Callback Busy (Camp-on))
– Transfer Recall (® 4.1.10 Call Transfer)
– Hold Recall (® 4.1.4 Call Hold)
– Call Park Recall (® 4.1.7 Call Park)
PC Programming Manual References
9.30 PBX Configuration—[1-2] Configuration—Portable Station—PS Registration and De-registration
10.6.1 PBX Configuration—[2-6-1] System—Numbering Plan—Main—Features—
Wireless XDP Parallel
Mode Set / Cancel
10.7.1 PBX Configuration—[2-7-1] System—Class of Service
—COS Settings—Optional Device & Other
Extensions—
Accept Wireless XDP Parallel Mode Set by PS
12.1.1
PBX Configuration—[4-1-1] Extension—Wired Extension—Extension Settings—Option 1—
Wireless
XDP / Shared Extension
Feature Manual References
4.1.22 COS (Class of Service)
Operating Manual References
1.3.78 Wireless XDP Parallel Mode
458 Feature Manual Document Version 2016-03
22.1.6 Wireless XDP Parallel Mode
To Next Page
Loading...
