Panasonic LP-310 - Laser Marker Communication Settings; System Offset and Communication Port

151
(2) System Offset
Move the position of the whole file to the X or Y direction.
(3) Communication Port
Set the communication port for controlling the laser marker using the communication.
Setting Range
:
-2.00 to +2.00mm
Use this parameter to correct the error specific to the laser marker or the error at setting.
Item Outline Setting Range
Baud rate
Specifies the communication speed of the transmission/
reception. This value indicates the information capacity
sent/received in one second.
1200/2400/4800/9600/19200/
38400
Select in the list box.
Parity
Specifies an error detection bit to each information
delimited by a stop bit.
NA/Odd/Even
Select in the list box.
Stop bit
Specifies the length of the delimiter signal of the information
sent/received.
1 bit/2 bit
Select in the list box.
Checksum
Specifies an error detection code to each information
delimited by a delimiter.
NA/Available
Select in the list box.
Delimiter
Specifies a symbol of rough separation on the informa-
tion sent/received.
CR/CR+LF
Select in the list box.
Refer to “4 External Control” (P.155) for details of the control of the laser marker using the com-
munication.
REFERENC
E
REFERENC
E