120
3-5-4 CAD Condition
On the CAD condition screen, the conditions for setting the marking of the data created by AutoCAD and so
on (DXF file) are set.
Item Description Setting Range
1. CAD No. Selects the registration No. of the CAD data to be marked
using the list box.
1 to 15
2. CAD File Selects CAD file to be marked. Select file using
the list box.
3. Font Selects the font to be used for displaying the character by
the setting software and for marking by the laser marker in
case that the character is used for each CAD file.
Select font using
the list box.
4. Size Appoint Specifies the method of either converting read image data
with leaving the ratio between the height and width, or con-
verting the data with specifying both the height and width
(regardless of the ratio between the height and width).
• X/Y-Same
• X/Y-Appoint
• X-Appoint
• Y-Appoint
5. Size Specifies the size of X/Y directions of the rectangle to
which a converted CAD data are circumscribed.
0.03 to 50.00mm
(Step: 0.01mm)
6. Laser Power Revise Enables to set the correction for the laser power set on the
laser setting screen.
0 to 200%
7. Scan Speed Revise Enables to set the correction for the scan speed set on the
laser setting screen.
50 to 200%
8. Origin Specifies which part of the graphic is aligned to the origin
(0, 0) of the coordinate system.
Select 6 locations
on a graphic.
9. X/Y Position
Moves the origin of the CAD file data in the X direction for the
X position and in the Y direction for the Y position respectively.
+/-25.00mm
(Step: 0.01mm)
10. Rotation Angle
Rotates CAD file data around the position of the origin. The
counterclockwise direction is the forward direction.
+/-180.0 °
(Step: 0.1°)
11. CAD Cond. COPY Copies the whole CAD condition. -
12. CAD Cond. PASTE
Pastes the whole CAD condition copied to the condition with
other CAD No.
-
13. CAD Cond. DELETE Deletes whole CAD condition. -
To Next Page
Loading...
