119
(2) Bold
Set the bold width of the character stroke.
Setting range: 0.00 to 6.00mm
(Note that this item max. available bold width of the character stroke must be one-fourth of whichever smaller
one of character height and character width. In case of inputting larger value than this limit, the error message
“Specify bold character line width in the range of 0.00 to ** [mm].” is appeared on the “Warning”.)
(3) Laser power revise and scan speed revise
In case of using the bold character marking function, it may influence the marking quality. Therefore,
be sure to confirm the marking quality with the test marking, and then apply to the actual marking.
In case of marking the bold character, set the value with the ratio of the character height against
the character width be one-fourth to four.
• Laser Power Revise :
Setting of the correction for the laser power set on the laser setting screen in the
range of the setting line.
Setting range: 0 to 200%
• Scan Speed Revise :
Setting of the correction for the scan speed set on the laser setting screen in the
range of the setting line.
Setting range: 50 to 200%
• If the value multiplied laser power correction by laser power is 100 or more, 100 is applied for
the correction.
• If the value multiplied scan speed correction by scan speed is 2000mm/s or more, 2000mm/s is
applied for the correction.
To Next Page
Loading...
