156
4-1
Control Through I/O Connector
4-1-1
Before External Controlling Laser Marker Using I/O Connector
■ Flow
When turning ON the key switch of the laser marker, the system is started. When the laser marker
is ready for marking after the laser is excited, the READY output signal is output.
When turning ON the key switch of the laser marker, the product becomes remote mode (external control
mode)
.
When performing the guide display and test marking from the PC, release the remote mode following
the indication displayed on the PC screen, and set the mode of the laser marker into PC control mode.
1. Turn ON the power supply of the laser marker.
2. Control the laser marker from the external.
Turn the key switch of the power supply BOX clockwise.
Perform the external control following the contents of this chapter.
To Next Page
Loading...
