Trips and Fault Finding
Alert Message IDs
ID Message Reason
6901 Keypad 6511 Keypad
33
NEW POWER DATA
DEFAULTS LOADED
CODE
Power board data on the control board does not
match that on the stack eeprom.
34
LANGUAGE
DEFAULTS LOADED
LANG Default language and frequency settings lost.
35
USING BACKUP
LANGUAGE
LANG Obsolete message
36
APPLICATION
NOT FOUND
DATA
Attempt to save fixed parameter set before it is
valid.
37
AUTOTUNE
IN PROGRESS
ATN
38 OPERATOR OPER
Alert displayed while changing to the operator
menu on pressing the PROG key.
39 DIAGNOSTIC DIAG
Alert displayed while changing to the
diagnostic menu on pressing the PROG key.
40 QUICK SETUP SET
Alert displayed while changing to the quick
setup menu on pressing the PROG key.
41 SETUP PAR
Alert displayed while changing to the setup
menu on pressing the PROG key.
42 SYSTEM SYS
Alert displayed while changing to the system
menu on pressing the PROG key.
1
2
3
4
5
6
7
8
9
10
11
A
B
C
D
E
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D Page
10-21
To Next Page
Loading...
Need help?
General
