Parker ac890 - Page 59

890CS & 890CD Common Bus Units
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D Page 4-39
8
9
10
11
A
B
C
D
1
2
3
4
5
6
7
E
8
9
1
2
3
4
5
6
E
Control Modes
4-Q
4-Q REGEN
Set-up using 4Q Regen active front end (AFG) control mode.
Refer to Chapter 7 to correctly set-up the drive for an 890CD/SD 4-Q Regen
AFE Application.
Autotune is not required.
PMAC
PMAC
Set-up using PMAC (Permanent Magnet AC) servo or torque motor control
mode - a high performance application where the drive uses Resolver or
Sin/Cos Encoder motor feedback.
In this mode, speed feedback signals from the motor shaft encoder are
processed to determine the rotational speed of the shaft. A PI algorithm within
the software uses this information to produce varying gate drive signals to the
drive circuits. These signals cause the drive to output the required voltage and
frequency for a particular motor speed.
Autotune is not required.
The Motor Selection Wizard in the 890 DSE Configuration Tool MUST be
used to correctly set-up the motor and feedback device parameters. Failure to
do so may result in damage to the servo motor.