84
Input DISTANCE (Distance from SP to point on the
arc).
If you finish the input of DISTANCE, press [ENT].
Then you go to OFFSET input screen.
Input OFFSET (Offset distance from the arc to offset
point).
If you finish the input of OFFSET, press [ENT].
Then you go to RESULT OF ARC DISTANCE
OFFSET screen.
You can see the coordinates of offset point from the
arc.
Press [F5][ENT] to save the coordinates of offset
point.
The PN, X, Y, Z and PC are viewed and can be edited.
If all items are OK, press [F5][ACCEPT] to save them.
To Next Page
Loading...
