94
Press [ENT] to open the input window of PN, X, Y,
Z and IH value.
Input each Character or value and press
[F5][ACCEPT] to view the STATION POINT
H. ANGLE SETUP screen.
Input the H. angle by pressing [F2][INPUT], [F3][0SET] and [F4] [HOLD] or Backsight
Coordinates by pressing [F5][BSP].
Press [ENT] to open the input window when using [F5][BSP].
Pressing [F2][INPUT]
Input any horizontal angle.
Pressing [F5][BSP]
The information for Back sight point is obtained.
Press [ENT] to finalize the input.
Aim at the reference point, and press [ENT] to view
the MEASURE screen.
Aim at point 1 and press [F1][ MEAS].
Measured Coordinates are displayed.
Press [ENT] to view the same MEASURE screen.
In the same manner, aim at point 2 and press [F1][
MEAS].
Measured Coordinates are displayed.
To Next Page
Loading...
