PISTON AND CONNECTING ROD ASSEMBLIES 13
7 Clean the connecting rod cap and the lower half
of the shell bearings. Fit the bearing to the cap;
ensure that the location tag is fitted correctly in its
recess. Lubricate the bearing with clean engine
lubricating oil. Fit the cap and ensure that the
assembly number is the same as that on the
connecting rod and that the numbers are on the
same side. Fit the fasteners; ensure that the flat
side of the head of the bolts is towards the
connecting rod. When the fasteners are nuts, new
nuts must be fitted. Tighten the fasteners gradually
and evenly to the recommended torque of 155 Nm
(114 lbf ft) 15,8 kgf m for setscrews, or 125 Nm
(92 lbf ft) 12,7 kgf m for nuts.
8 Check that the crankshaft will rotate freely.
9 Check the piston height above the top face of
the cylinder block, operation 13A-05.
10 Fit the lubricating oil strainer and suction pipe,
operation 19A-04 or fit the balancer unit, operation
14A-10.
11Fit the lubricating oil sump, operation 19A-03.
12Fit the cylinder head assembly, operation
12A-07.
13 Fill the sump to the correct level with lubricating
oil of an approved grade.
14 Fill the cooling system.
Perkins Phaser/1000 Series, April 1995 13A.07
To Next Page
Loading...
