Web-based management (WBM)
107709_en_00 PHOENIX CONTACT 117 / 140
The controller is then restored to the factory default settings and restarted automatically.
Restarting the controller • Deactivate the check box “Reset to factory default settings”.
• Enter the password in the “Enter password” input field.
• Click on “Apply and Restart”.
The controller is restarted.
Please note:
When restoring the factory default settings, all application-specific data
(PC Worx Engineer project, IP settings, password, etc.) for the controller is deleted. After
restoring the settings, you must reconfigure the controller and assign a new password.
If you have not changed the password, you must enter the default password. The default
password is “private”.
To Next Page
Loading...
Need help?
General
