Phoenix Contact AXC F 1050 User Manual

AXC F 1050
26 / 140
PHOENIX CONTACT 107709_en_00
AXC: Axioline F diagnostics
D
Red/yel-
low/green
Axioline F: Diag-
nostics for local
bus communica-
tion
Off
Power down:
Device is in (power) reset
On green
Run:
The Axioline F station is ready for operation; communication
within the Axioline F station is OK.
All data is valid. No malfunction is present.
Flashing
green
Active:
The Axioline F station is ready for operation; communication
within the Axioline F station is OK. The data is not valid. There
is no valid data available from the controller. No malfunction is
present on the device.
Yellow on
Ready:
The Axioline F station is ready for operation; no data is being
exchanged.
Flashing
yellow/red
Local bus error during active I/O check
Flashing
red
Local bus error during startup
Possible causes:
– Configuration cannot be generated, information is missing
from a device
– Chip version of a device is <V 1.1
– Deviation between actual and required configuration
– No local bus device connected
– The maximum number of local bus devices has been ex-
ceeded
Red on
Bus error in RUN status
The Axioline F station is ready for operation but has lost con-
nection to at least one device.
Possible causes:
– Communication error
– A local bus device has been removed or a configured de-
vice is missing
– Reset from a local bus device
– Serious device error at a local bus device (local bus device
can no longer be reached)
E
Yel-
low/red
Error/warning
Yellow on I/O warning at an Axioline F device
Red on Peripheral fault at an Axioline F device
PWR: Supply voltage (communications power U
L
)
UL Green U
Logic
Off 24 V communications power feed-in not present or too low.
On 24 V communications power feed-in present.
Table 3-1 Controller diagnostics and status indicators
Desig-
nation
Color Meaning Status Description

Phoenix Contact AXC F 1050 Specifications

General

Brand	Phoenix Contact
Model	AXC F 1050
Category	Controller
Language	English