EasyManua.ls Logo

Piper Warrior III - Page 78

Piper Warrior III
1104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PIPER AIRCRAFT, INC.
PA-28-161, WARRIOR III
MAINTENANCE MANUAL
PAGE 6
Nov 30/06
1E6
5-50-00
5. Flood Damage, Immersion in
W
ater (continued)
Item Inspection Inspection Interval
Electrical Systems. Replace all circuit breakers and If immersed, each event,
switches. before further flight.
Replace all solenoids, relays and
master contactors.
Replace battery.
Disassemble all connectors; clean
and inspect for corrosion. Replace all
corroded or pitted connectors. Inspect
for wire corrosion at connector.
Check all harness assemblies for
entrapped contaminants. Clean and
check for short circuits.
Remove electric motors and electric
pumps.
Remove all potted solid state electrical
equipment such as alternator inop.
switches, low fuel warning switches, etc.
Clean, dry and bench check per
appropriate maintenance manual.
Clean and check voltage regulators and
overvoltage relays. Replace as necessary
Clean and check aIl strobe light power
supplies. Refer to appropriate
maintenance manual.
Replace all fuel senders, etc.
Clean, inspect and check heated
pitot systems.
Autopilot System. Bench test in accordance with If immersed, each event,
(If Installed.) appropriate maintenance manual. before further flight.
Pay particular attention to clutch settings.

Table of Contents

Related product manuals