User’s Manual of GS-5220 LCD Series
138
4.2.22 Configure Delete
The Configure Delete page allows to delete the startup-config and default-config files which are stored in FLASH.
If this is done and the switch is rebooted without a prior Save operation, this effectively resets the switch to
default configuration. Please refer to the Figure 4-2-27 shown below.
Figure 4-2-27: Configuration Delete Page Screenshot
4.2.23 Image Select
This page provides information about the active and alternate (backup) firmware images in the device, and
allows you to revert to the alternate image. The web page displays two tables with information about the active
and alternate firmware images. The Image Select screen in Figure 4-2-28 appears.
In case the active firmware image is the alternate image, only the "Active Image" table is
shown. In this case, the Activate Alternate Image button is also disabled.
1. If the alternate image is active (due to a corruption of the primary image or by
manual intervention), uploading a new firmware image to the device will
automatically use the primary image slot and activate this.
2. The firmware version and date information may be empty for older firmware
releases. This does not constitute an error.
To Next Page
Loading...
Need help?
General