User’s Manual of GS-5220 LCD Series
296
Figure 4-9-1: QoS Ingress Port Policers Page Screenshot
The page includes the following fields:
Object Description
• Port
The port number for which the configuration below applies.
• Enable
Controls whether the policer is enabled on this switch port.
• Rate
Controls the rate for the policer. This value is restricted to 100-1000000
when the "Unit" is "kbps" or "fps", and it is restricted to 1-3300 when
the "Unit" is "Mbps" or "kfps".
The default value is 500.
• Unit
Controls the unit of measure for the policer rate as kbps, Mbps, fps or
kfps .
The default value is "kbps".
• Flow Control
If flow control is enabled and the port is in flow control mode, then
pause frames are sent instead of discarding frames.
To Next Page
Loading...
