User’s Manual of GS-5220 LCD Series
407
IP Address - IP address and UDP port for the authentication
server in question.
State - Shows the state of the server. It takes one of
the following values:
Disabled: The selected server is disabled.
Not Ready: The server is enabled, but IP
communication is not yet up and running.
Ready: The server is enabled, IP
communication is up and running, and the
RADIUS module is ready to accept access
attempts.
Dead (X seconds left): Access attempts
were made to this server, but it did not
reply within the configured timeout. The
server has temporarily been disabled, but
will get re-enabled when the dead-time
expires. The number of seconds left before
this occurs is displayed in parentheses. This
state is only reachable when more than
one server is enabled.
Round-Trip
Time
radiusAuthClie
ntExtRoundTrip
Time
The time interval (measured in milliseconds)
between the most recent
Access-Reply/Access-Challenge and the
Access-Request that matched it from the
RADIUS authentication server. The granularity
of this measurement is 100 ms. A value of 0 ms
indicates that there hasn't been round-trip
communication with the server yet.
To Next Page
Loading...
Need help?
General