Polaris RANGER XP 1000 2018 - Shift Cable Service;Inspection; Shift Lever Removal;Installation

6
9928487 R01 - 2018 RANGER XP 1000 Service Manual
© Copyright Polaris Industries Inc.
6.5
SHIFT CABLE SERVICE
SHIFT LEVER REMOVAL / INSTALLATION
1. Remove the shift knob cover
q
. Remove retaining
screw
w
and shift knob
e
from the shift lever
r
.
2. Remove the four push rivets retaining the upper dash
panel and remove the panel to access the shift lever.
3. Remove the rubber grommet
t
from the dash and
shift lever
r
.
4. Remove nut
s
retaining the shift cable
i
to the shift
lever
r
. Disconnect cable end from the lever.
5. Remove the retaining ring
o
and slide the shift lever
r
off the mounting bracket and out from the frame.
6. Remove both bushings
a
from the shift lever and
service as needed.
7. Perform the previous steps in reverse order to
reinstall the shift lever (lever, cable, dash panel, shift
knob).
SHIFT CABLE INSPECTION
Shift cable adjustment may be necessary if symptoms
include:
• No gear position or AWD display on instrument cluster
• Ratcheting noise on deceleration
• Inability to engage into a gear
• Excessive gear lash (noise)
• Gear selector moving out of desired range
Inspect shift cable, clevis pins, and pivot bushings and
replace if worn or damaged.
TRANSMISSION