5
5.27
9925724 R01 - 2014-2015 RZR XP 1000 / RZR XP4 1000 Service Manual
© Copyright 2014 Polaris Industries Inc.
8. Tighten the spider jamb nut using Clutch Spider Nut
Socket (PU-50578). Torque jam nut to specification.
Spider Jamb Nut:
250 ft-lb (339 Nm)
(Apply 0.1 mL Loctite® 7088 Primer and 0.1 mL
Loctite® 620™) in 90° apart to the threads of the
spider jamb nut.
9. After the spider and jamb nut have been torqued,
remove the clutch assembly from the holding fixture
and inspect the alignment marks made during
disassembly.
NOTE: If the marks illustrated below are not in
alignment upon assembly, the clutch will not be
in balance and the drive clutch assembly must
be replaced.
10. Install the limiter spacer
and the clutch spring
.
CAUTION
DO NOT reassemble the drive clutch without the limiter
spacer. Belt life will be greatly reduced.
11. Install the drive clutch cover
. Be sure all alignment
marts are in alignment.
12. Install cover bolts and torque in a cross pattern
evenly to specification.
Drive Clutch Cover Bolts:
9 ft-lb (12 Nm)
PVT SYSTEM
To Next Page
Loading...
Need help?
General
