RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Getting Started Guide
Polycom®, Inc. 65
2 Click Next.
Fast Configuration Wizard – IP Signaling
Field Description
Network Service Name The name Default IP Service is assigned to the IP Network Service by the Fast
Configuration Wizard. This name can be changed.
Note: This field is displayed in all IP Signaling dialog boxes and can contain
character sets that use Unicode encoding.
Signaling Host
IP Address
Enter the address to be used by IP endpoints when dialing into the MCU.
Dial out calls from the Collaboration Server are initiated from this address.
This address is used to register the Collaboration Server with a Gatekeeper or a SIP
Proxy server.
In the RealPresence Collaboration Server 1800, this field is disabled as only one IP
address is used for the Signaling Host and the Media Card and it is defined by the
Media Card IP address.
Media Card 1-4
IP Addresses
Enter the IP address(es) of the media card (s) (MPMx/MPMRx 1 and MPMx/MPMRx
2-4 (if installed)) as provided by the network administrator. Endpoints connect to
conferences and transmit call media (video, voice and content) via these addresses.
In the RealPresence Collaboration Server 1800, one IP address is used for the
signaling and media.
Enter the address to be used by IP endpoints when dialing into the MCU.
Dial out calls from the Collaboration Server are initiated from this address.
This address is used to register the Collaboration Server with a Gatekeeper or a SIP
Proxy server.
Subnet Mask Enter the subnet mask of the MCU.
Default value: 255.255.255.0.
• To set the Collaboration Server to Secured Communication, first complete the Fast Configuration
Wizard and reset the Collaboration Server. After Login, install the Certificate and then enable
Secured Communication Mode.
• The IP Network Service configured using the Fast Configuration Wizard will be saved only if
Media cards are installed in the Collaboration Server.
To Next Page
Loading...
