Polycom 1500 - Connecting Cables to the Realpresence Collaboration Server (RMX) 2000

RealPresence Collaboration Server (RMX) 1500/1800/2000/4000 Getting Started Guide
Polycom®, Inc. 44
 Fasten the Collaboration Server to the rack spacers using the flat head screw (item 8) with
flat washer
(item 9) through the two holes in the Collaboration Server’s front mounting
brackets.
● Using a shelf:
 Install the shelf, supplied by the rack manufacturer, in the rack.
 Mount the Collaboration Server on the shelf.
 Fasten the Collaboration Server to the rack with screws through the four holes in the Collaboration
Server’s front mounting brackets.
Connecting Cables to the RealPresence Collaboration Server (RMX) 2000
Connect the following cables to the back panel:
● Required. Power cable.
● Required. On the RTM IP card connect the LAN cable to LAN 2 Port.
Refer to Detail of Front Rack Spacer Assembly for all Collaboration Server types for installation
instructions.
Do not remove the protective caps from LAN1, LAN3 and ShMG ports.