Raritan PM Series User Manual

Chapter 3: Using the Web Interface
171
Field/setting
Description

Static : Manually configure the IPv4 settings.
• DHCP settings: Optionally specify the preferred hostname, which
must meet the following requirements:
 Consists of alphanumeric characters and/or hyphens
 Cannot begin or end with a hyphen
 Cannot contain more than 63 characters
 Cannot contain punctuation marks, spaces, and other symbols
• Static settings: Assign a static IPv4 address, which follows this
syntax "IP address/prefix length".
Example: 192.168.84.99/24
IPv6 settings:
Field/setting
Description
Enable IPv6 Enable or disable the IPv6 protocol.
IP Auto
Configuration
Select the method to configure IPv6 settings.

Automatic : Auto-configure IPv6 settings via
DHCPv6.

Static : Manually configure the IPv6 settings.
• Automatic settings: Optionally specify the preferred hostname,
which must meet the above requirements.
• Static settings: Assign a static IPv6 address, which follows this
syntax "IP address/prefix length".
Example: fd07:2fa:6cff:1111::0/128
Common Network Settings
Common Network Settings are OPTIONAL, not required. Therefore, leave
them unchanged if there are no specific local networking requirements.
Field
Description
Cascading Mode Leave it to the default "None" unless you are
establishing a cascading chain.
For more information, refer to:
 Cascading Multiple BCM2 Devices for Sharing
Ethernet Connectivity

Setting the Cascading Mode
(on page 183)

Raritan PM Series Specifications

General

Brand	Raritan
Model	PM Series
Category	Measuring Instruments
Language	English