Because RFL™ and Hubbell® have a policy of continuous product improvement, we reserve the right to change designs and specifications without notice.
RFL DS-64NC RFL Electronics Inc.
August 1, 2007 2 (973) 334-3100
SPECIFICATIONS
As of the date this Instruction Data Sheet was published, the following specifications apply to the RFL
DS-64NC Wideband Synchronous Data Module. Because all RFL products undergo constant
refinement and improvement and, these specifications are subject to change without notice.
DATA PORT
Data Rates:
In a T1 Multiplexer: 8 Kbps to 1.536 Mbps in 8-Kbps increments.
In a T1-Based Variable-Rate Multiplexer: 8 Kbps to 1.536 Mbps in 8-Kbps increments.
In a 2MB Multiplexer: 8 Kbps to 1.984 Mbps in 8-Kbps increments.
In a 2MB-Based Variable-Rate Multiplexer: 8 Kbps to 2.040 Mbps in 8-Kbps increments.
Data Format: no restrictions on data content. Supports clear-channel for AMI networks.
Data Interface: Selected by choosing appropriate Module Adapter:
Using MA-412A Module Adapter: RS-449, configured as DCE.
Using MA-413A Module Adapter: CCITT V.35, configured as DCE.
Using MA-414A Module Adapter: RS-449, configured as DTE.
Using MA-415A Module Adapter: CCITT V.35, configured as DTE.
Using MA-427 LAN Bridge Module Adapter.
Signals Supported:
RS-449: SD, TT, ST, RS, CS, RD, RT, RR, DM, TM and SG.
CCITT V.35: SD, SCT, SCTE, RD, RTS, SCR, CTS, DSR, RLSD, LT and SG.
Timing:
DTE: Synchronizes network to receive timing input. Provides terminal timing output
synchronized to network.
DCE: Provides send and receive timing synchronized to the network. Can synchronize
network to terminal timing
Transmit And Receive Buffers: 12-Kbyte deep buffers, with user-selectable starting depth; either
256 bits for synchronous operation, or 6000 bits to support plesiochronous operation.
To Next Page
Loading...
