USING SERVICE PROGRAM MODE
B044/B045/B046 5-12 SM
4
Mode Number/Name Function/[Setting]
932* Auto Density Adjustment
[-2 ~ 2 / 0 / 1/step] DFU (Not effective on this machine.)
933* Blank-Page Sensor Level Adjustment
[-2 ~ 2 / 0 / 1] DFU (Not effective on this machine.)
Peak Setting934*
Sets adjustment the machine will use when setting white
peak prior to start of scanning, for the mode selected by
SP4-921.
[–128 ~ 127 / 0 / 1/step]
• If AE tracking is enabled, the applied peak becomes:
[(detected peak + this setting) x approx. 40%]
• If AE tracking is disabled, the applied peak becomes:
[(detected peak + this setting)
AE Tracking Speed935*
Adjusts the white-peak tracking speed for the mode
selected by SP4-921.
[–2 ~ 2 / 0 / 1/step]
Negative settings reduce the speed; positive settings
increase it.
Peak Offset Select936*
Sets the peak correction offset for the mode selected by
SP4-921.
[–2 ~ 2 / 0 / 1/step] IP
Negative settings produce better reproduction of low-
contrast originals. Positive settings provide better
elimination of dirty background.
Plotter Mode Select961*
Selects the plotter mode used by the processing mode
selected by SP4-921. IP
[0 = Selected processing mode's default /
1 = Normal (no correction) / 2 = Toner save /
3 = FCI
• The default varies according to the processing mode
selected by SP4-241
Marking Image Density Conversion962*
Selects the image density conversion for the processing
mode selected by SP4-921.
[–2 ~ 2 / 0 / 1/step] IP
A setting of "0" sets conversion OFF. Negative settings
reduce the black marking size, while positive values
magnify it.
963* Marking Image Density Setting
Sets the density adjustment type for the mode selected by
SP4-921. IP
[0 ~ 5 / 0 / 1/step], where:
0: The mode's default value is used.
1: Distortion prevention
2: Distortion prevention and edge correction
3: Normal
4: Light edge correction
5: Dense edge correction
To Next Page
Loading...
