BIT SWITCHES
B465 5-14 SM
System Switch 11
No. FUNCTION COMMENTS
6 Memory reception if no RTI or CSI
received
0: Reception disabled
1: Reception enabled only when
there is no problem with the
printer mechanism
This switch setting is dependent on user
parameter switch 05 bit 1.
This Sw U.P.05 bit 1
-- 0 : Reception always enabled
0 1 : Reception disabled
1 1 : Reception enabled only
there is no problem with
the printer mechanism
7 Not used Do not change the setting.
System Switch 12
No. FUNCTION COMMENTS
0–7 TTI printing position in the main
scan direction
08 to 92 (BCD) mm. Only input even numbers.
This setting determines the TTI print start
position from the left edge of the paper. If the
TTI is too far to the right, the file number,
which is on the top right of the page, may
obscure it.
System Switch 13 - Not used (do not change any of these settings)
System Switch 14 - Not used (do not change any of these settings)
System Switch 15
No. FUNCTION COMMENTS
0 Not used Do not change this setting.
1 Programming with European
characters
0: Disabled 1: Enabled
1: The user can program with European
characters (e.g. ”ä”, ”å”) for the TTI, Quick
Dial labels, etc.
2
Change NCU country code
0: Disabled 1: Enabled
0: The machine does not display “c.c.” in the
service mode 07: NCU, 0: NCU PARA
menu.
3 Not used Do not change the setting.
4 Daylight saving time automatic
adjustment (NA only)
0: Manual adjustment
1: Automatic adjustment
1: The clock is adjusted automatically at start
and end of daylight-saving time (in April and
October).
5–7 Not used Do not change these settings.
System Switch 16 - Not used (do not change any of these settings)
To Next Page
Loading...
