BIT SWITCHES
SM 5-23 B465
Fax Unit
B465
Communication Switch 0D
No. FUNCTION COMMENTS
0–7 The available memory
threshold, below which
ringing detection (and
therefore reception into
memory) is disabled
00 to FF (Hex), unit = 2 KB
(e.g. 0C(H) = 24 KB)
One page is about 24 KB.
The machine refers to this setting before each fax
reception. If the remaining memory is below this
threshold, the machine cannot receive fax
messages.
If this setting remains at 0, the machine will detect
ringing signals and enter receive mode even if there
is no available memory. This will result in
communication failure.
Communication Switch 0E
No. FUNCTION COMMENTS
0–7 Minimum interval between
automatic dialing attempts
06 to FF (Hex), unit = 2 s
(e.g., 06(H) = 12 s)
This value is the minimum time that the machine
waits before it dials the next destination.
Communication Switch 0F - Not used (do not change any of these settings)
Communication Switch 10
No. FUNCTION COMMENTS
0–7 Memory transmission:
Maximum number of dialing
attempts to the same
destination
01 - FE (Hex) = 1 - 254 times
Communication Switch 11 - Not used (do not change any of these settings)
Communication Switch 12
No. FUNCTION COMMENTS
0–7
Memory transmission: Interval
between dialing attempts to
the same destination
00 - FF (Hex) = 0 - 255 minutes
Communication Switch 13 - Not used (do not change any of these settings)
To Next Page
Loading...
