PAPER TRAY UNIT HEATER
SM 1-15 B044/B045/B046
Installation
10. Pass the heater's harness through the
hole [A] at the rear of the copier.
11. Pass relay harness [B] through the
circular opening at [C] (at the rear of the
PSU board bracket), and then through
the hole at [A]. Then connect the relay
harness to the heater's harness [D].
12. Pull the relay harness back into the
copier. Then set the ferrite core [E]
over the relay harness, and push it
back so that it is over the heater's
harness.
13. Wrap the heater's harness once
around the core (see [F]). Adjust so
that the core is located toward the
rear of the copier (at position [E],
behind the rear clamp). Secure the
core into position using the supplied
tie wrap [G].
14. Clip off the excess length of the tie
wrap [H].
15. Connect the relay harness connector [I] to the large connector at the front
center of the PSU board. Screw the ground wire [J] to the PSU board bracket,
using the included grounding screw.
16. Attach the supplied clamps [K] to corresponding holes on the PSU board
bracket, and set the heater harness though the clamps. Position the harness
so that the front clamp is between the two bindings [L] on the harness. Then
fasten the clamps.
B046I520.WMF
B046I521.WMF
[A]
[B]
[C]
[D]
[E]
[F]
[G]
[H]
[I]
[J]
[L]
[K]
To Next Page
Loading...
