System SP Table-2
SM Appendix 4-27 D009/D011/D012/D013/D091/D092
Appendix:
Service
Program
Mode Tables
004
Leading Edge: 2nd Side
[10 to 100 / 20 / 1
A ]
Adjusts the transfer current for copying at leading edge the second side of
the paper.
Increase the current to separate the paper from the drum properly in high
humidity and high temperature conditions.
005
By-pass: Image Area
[10 to 100 / 45 / 1
A ]
Adjusts the transfer current for copying from the by-pass tray.
If the user normally feeds thicker paper from the bypass tray, use a higher
setting.
006
By-pass: Leading Edge
[10 to 100 / 20 / 1
A ]
Adjusts the transfer current for copying at the leading edge of paper fed
from the by-pass tray.
Increase the current to separate the paper from the drum properly in high
humidity and high temperature conditions.
008
No Image Area
[10 to 100 / 15 / 1
A ]
Adjusts the transfer current for copying.
2309* Current: Paper Size Correction
001
Paper Lower Width (a)
[1 to 150 / 150 / 1 mm ]
Adjusts the lower paper width threshold for the transfer current, charge
voltage, and development bias corrections.
Use this SP when an image problem (e.g., insufficient toner transfer) occurs
with a small width paper. If the paper width is smaller than this value, the
transfer current will be multiplied by the factor in SP2-309-3 (paper tray) or
SP2-309-5 (by-pass).
To Next Page
Loading...
