System SP Table-2
D009/D011/D012/D013/D091/D092 4-32 SM Appendix
002
C-beta
[0 to 400 / 0 / 10vol ]
Adjusts the charge roller voltage used when paper with a small width is fed
from the by-pass tray. The paper width below which the correction starts
depends on the value of SP2-309-2.
Use this SP when an image problem (see 2-914-1) occurs when paper with
a small width is fed from the by-pass feed tray.
003
B-gamma
[0 to 300 / 200 / 10vol ]
Adjusts the development bias used when paper with a small width is fed
from the by-pass tray. The paper width below which the correction starts
depends on the value of SP2-309-1.
Use this SP when an image problem (see 2-914-1) occurs when paper with
a small width is fed from the by-pass feed tray.
004
B-delta
[0 to 300 / 50 / 10vol ]
Adjusts the development bias used when paper with a small width is fed
from the by-pass tray. The paper width below which the correction starts
depends on the value of SP2-309-2.
Use this SP when an image problem (see 2-914-1) occurs when paper with
a small width is fed from the by-pass feed tray.
2960*
Toner Overflow Sensor
[0 = No, 1= Yes]
Selects whether or not the toner overflow sensor is activated.
To Next Page
Loading...
