System SP Table-2
SM Appendix 4-33 D009/D011/D012/D013/D091/D092
Appendix:
Service
Program
Mode Tables
2964*
Transfer Cleaning Blade Forming (SSP)
Applies a pattern of toner to the transfer belt at a defined interval between
sheets on the transfer belt in order to reduce friction between the belt
surface and the cleaning blade.
Under conditions of high temperature and high humidity, the density control
feature may reduce the amount of toner, which also reduces the amount of
toner on the surface of the transfer belt. With less toner on the belt, the
friction between the belt and the blade increases, and could cause the blade
to bend or scour the surface of the belt.
001 0: OFF, 1: ON
[0 to 1 / 0 / 1 ]
002 Pattern Interval
[1 to 100 / 15 / 1 sheet]
003 Pattern Number
[1 to 3 / 1 / 1 line]
004 Pattern LD Power
[0 to 15 / 2 / 1 ]
2972*
Grayscale Limit (SSP)
Controls the halftone density level to prevent deterioration of the OPC. The
halftone density is detected by the ID sensor, and the machine adjusts the
intensity of the LD beam according to the upper/lower limit setting.
001
Upper Limit
[0 to 100 / 58 (C1b/C1.5b), 63 (C1c/C1.5c)/
1vol ]
Defines the upper limit for grayscale.
A larger value allows a wider range of halftones at the pale end of the scale.
If the image contains pale areas with fuzzy borders surrounded by dark
areas, reduce this value to make the borders clearer.
To Next Page
Loading...
