Ricoh SP 3710DN - When Installing the New Main Board

Electrical Components
SM 4-79 M0C3/M0C4/M0C5/M0C6/M0C7
Replacement
and
Adjustment
When Installing the New Main Board
After replacing the main board, the following settings must be made correctly.
1. Enter the "Maintenance Mode", and set the SPs below;
• Destination
Four-line LCD models: SP menu > [Engine Maintenance] > [Destination]
Touch panel models: SP menu > [Engine Service Setting] > [Destination]
Destination Machine Code Setting Value
NA M0C3-17, M0C6-17, M0C4-17, M0C5-17, M0C7-17 1
EU/AA M0C3-27, M0C6-27, M0C4-27, M0C5-27, M0C7-27 2
CHN M0C3-21, M0C4-21, M0C5-21 4
TWN M0C3-19, M0C5-19 5
• Serial No.
Four-line LCD models: SP menu > [Engine Maintenance] > [Serial No.]
Touch panel models: SP menu > [Engine Service Setting] > [Serial No.]
Ask your supervisor about how to enter the "Maintenance Mode".
2. Do the registration adjustment (Registration Adjustment)
3. For @Remote models, make sure that the manual call can be performed.
If the serial number is not input correctly, @Remote service cannot be connected.