Maintenance Mode (for Touch Panel Models)
M0C3/M0C4/M0C5/M0C6/M0C7 5-26 SM
Print Reports
Menu Description
G3 Protocol dump list
G3 protocol dump of the latest communication is printed.
Off (Default)/ Error/ On
CTL SP
Menu Description
Air Print
Enable
Sets whether the Air Print function is enabled or disabled.
[Disable/ Enable (Default)]
Debug
Tools
[Off (Default)/ NIC/ USB]
Disable
USB Port
Sets the USB port function is valid or invalid
[Off (Default)/On]
Pas
Validity
Setting
When used to set Paas (Only for CHN)
[Inactive (Default)/ Active]
PDL Mode
ON = "PDL Settings" is shown in [Print List/Report] menu (Default)
OFF = "PDL Settings" is hidden
FW Update
Mode
If updating the firmware for a machine in which LDAP authentication is set, execute
this mode.
[Execute/ Return]
After pressing “Execute”, the display shows “Please Restart Machine….” Turn the
machine's main power off, and then on. Then the machine activates in a special
boot loader mode. After that, update the firmware via USB cable.
Auto IP
ON = Automatically set the IP address when the IP address cannot be acquired
(Default)
OFF = Continually try to obtain the IP address by DHCP
Factory Default
Menu Description
Factory
Default
Return Does not execute anything. Returns to an upper level.
Execute
Resets all the settings to factory default.