PaaS Setup Procedure
M0C3/M0C4/M0C5/M0C6/M0C7 2-2 SM Appendix
2.1.3 PAAS REGISTRATION
Make sure the machine’s main power is always turned on and connected to the internet during
registration.
1. Launch the web browser.
2. In the web browser’s address bar, enter http://(machine’s IP address)/ to access the
machine.
3. On the Web Image Monitor menu, select NPB Settings.
4. Check that [Operation] is set to "Contract Registration".
Operation List:
Item Description
Contract Registration Select this to enter the ID and Authentication Key after
registration.
Contract Status
Checking
Select this if the machine stops operating.
The machine asks the server about the registration status.
Contract Cancellation Select this to cancel the registration.
Device Replacement Select this to replace the machine being used.
To Next Page
Loading...
