Ricoh SP 3710DN - Top Cover

Exterior Covers (Printer Models)
SM 4-9 M0C3/M0C4/M0C5/M0C6/M0C7
Replacement
and
Adjustment
4.2.5 TOP COVER
1. Remove the front cover (Front Cover).
2. Remove the left cover (Left Cover).
3. Remove the rear cover (Rear Cover).
4. Remove the right cover (Right Cover).
5. Remove the four screws and a connector, and release the three hooks, and then remove the
top cover [A].
• When re-installing the top cover, always verify that the two paperweights [A] are
lifted. If they are not lifted to fit into the paper slot, the paperweights could be
damaged.
• Make sure that these paperweights can be moved smoothly (up and down) after
installing the top cover. If these paperweights do not move smoothly, try installing
the top cover again.