Maintenance Mode (for Four-line LCD Models)
SM 5-3 M0C3/M0C4/M0C5/M0C6/M0C7
Maintenance
Menu Description
Interval Setting
Corrects the face curl of paper.
0: OFF (32ppm)
1: Sets the engine speed to half after printing 1 minute.
2: Sets the engine speed at 13ppm.
[0 to 2 / 0 / 1 /step]
Toner Near
End
Sheets
Adjusts the printable sheets between "toner near end" and
"toner end".
[50 to 250 / 200 / 25 sheet/step]
Dot Count
Adjusts the printable dot count between "toner near end" and
"toner end".
[50 to 150 / 100 / 25 dot/step]
Subscan Magnification
Adjusts the sub scan magnification.
[-8 to 8 / 0 / 1/step]
Trans Roller Bias
Adjusts the transfer roller bias.
[-6 to 6 / 0 / 1/step]
Developer Bias
Adjusts the developer bias.
[270 to 330 / 250 / 15/step]
Charge Bias [1100 to 1300 / 1200 / 25/step]
Fusing Unit
Temperature
Plain Paper
Adjusts the fusing temperature for plain paper.
[150 to 200 / 175 / 1°C/step]
Recycled
Adjusts the fusing temperature for recycled paper.
[160 to 180 / 170 / 1°C/step]
Postcard
Adjusts the fusing temperature for postcards.
[170 to 200 / 185 / 1°C/step]
Envelope
Adjusts the fusing temperature for envelopes.
[170 to 200 / 185 / 1°C/step]
Thin Paper
Adjusts the fusing temperature for thin paper.
[155 to 180 / 170 / 1°C/step]
Low Power
Adjusts the fusing temperature in the low power mode.
[80 to 135 / 120 / 1°C/step]
Standby
Adjusts the fusing temperature in the standby mode.
To Next Page
Loading...
