Ricoh SP 3710DN - Page 150

Maintenance Mode (for Touch Panel Models)
M0C3/M0C4/M0C5/M0C6/M0C7 5-16 SM
Menu Description
Vert. Tray2
Thick
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Vert. Tray2
Thin
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Horiz.
Bypass
[-40.0 to 40.0 / -5.0 (Default) / 0.1 mm/step]
Vert. Bypass
Plain
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Vert. Bypass
Thick
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Vert. Bypass
Thin
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Horiz. Dup.
Back
[-40.0 to 40.0 / 8.0 (Default) / 0.1 mm/step]
Vert. Dup.
Plain
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Vert. Dup.
Thick
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Vert. Dup.
Thin
[-40.0 to 40.0 / 17.0 (Default) / 0.1 mm/step]
Reset Transfer Unit Clears the EM counter of the transfer roller.
Reset Fuser Unit Clears the EM counter of the fusing unit.
Fuser SC Reset This menu is for resetting an SC related to a fusing error.
2 Beam LD Power
Adjusts the LD power.
[74 to 137 / 106 (Default) / 1/step]
Interval Setting
Corrects the face curl of paper.
0: OFF (32ppm)
1: Sets the engine speed to half after printing 1 minute.
2: Sets the engine speed at 13ppm.
[0 to 2 / 0 / 1 /step]
Toner Near
End To End
Sheets
Adjusts the printable sheets between "toner near end" and
"toner end".
[50 to 250 / 200 / 25 sheet/step]
Dot Count
Adjusts the printable dot count between "toner near end" and