Paper Feed
M0C3/M0C4/M0C5/M0C6/M0C7 7-32 SM
The by-pass paper feed roller stops after each rotation due to the on/off movement of the
solenoid (when off, spring pressure pulls the latch back down so that it catches on a cog).
No. Item
1. By-pass feed roller
2. Metal plate
In addition to the two cams allowing the by-pass tray to lower slightly after feeding, a curved
metal plate (attached to one side of the by-pass feed roller) allows paper to slide past the roller
upon completion of each single rotation of the roller while the paper is still feeding.
To Next Page
Loading...
