Ricoh SP 3710DN - Page 37

Settings for @Remote Service (for MF Models)
SM 2-11 M0C3/M0C4/M0C5/M0C6/M0C7
Installation
Item Settings
Touch panel: SP menu > [@Remote] > [Remote Service] >
[Proxy Password]
2. Get a Request Number.
3. Enter the "Maintenance Mode (SP mode)".
4. Check if the function flag is "Disable (Default)".
Four-line LCD panel: SP menu > [@Remote] > [Remote Service] > [Function Flag]
Touch panel: SP menu > [@Remote] > [Remote Service] > [Function Flag]
Execute the @Remote Settings
1. Enter the "Maintenance Mode (SP mode)".
2. Check if the @Remote status is "0".
Four-line LCD panel: SP menu > [@Remote] > [Remote Service] > [Instl:Condition]
Touch panel: SP menu > [@Remote] > [Remote Service] > [Regist Status]
If the @Remote status is not "0", ask the @Remote Center Administrator.
3. Check that the device ID2 has been programmed correctly.
Four-line LCD panel: SP menu > [@Remote] > [Machine No. Setting] > [ID2 Code
Display]
Touch panel: SP menu > [@Remote] > [Machine No. Setting] > [ID2 Code Display]
• 6 spaces must be put between the 3-digit prefix and the following 8-digit number (e.g.
xxx______xxxxxxxx).
• ID2 and the serial number must be the same (e.g. ID2: A01______23456789 = serial
No. A0123456789)
The procedure for checking the serial number is as follows;
Four-line LCD panel: SP menu > [Engine Maintenance] > [Serial No.]
Touch panel: SP menu > [Engine SN SP] > [Serial No.]
4. Input the request number which you have obtained from the @Remote Center GUI, and then
enter [OK].
Four-line LCD panel: SP menu > [@Remote] > [Remote Service] > [Instl:ID #]
Touch panel: SP menu > [@Remote] > [Remote Service] > [Letter Number]
5. Confirm the Request Number.
Four-line LCD panel: SP menu > [@Remote] > [Remote Service] > [Instl:Reference]
Touch panel: SP menu > [@Remote] > [Remote Service] > [Confirm Execute]