<M> Settings / General / Communication / Synopta settings
Reset config ID
If the Synopta port is used by a different controller, then the
port can be reset by switching this setting to Yes.
8.3.4 Network settings
<M> Settings / General / Communication / Network Settings
IP Address
Subnet mask
Update server active
8.3.5 Modbus Settings
<M> Settings / General / Communication / Modbus settings
Model
RTU
Baud rate
19200
Data bits
8
Stop bits
1
Parity
Even
8.3.6 EC calibration
<M> Settings / General / EC calibration
To calibrate the EC sensor, follow the step-by-step instructions
on the unit's display.
8.3.7 pH calibration
<M> Settings / General / pH calibration
To calibrate the pH sensor, follow the step-by-step instructions
on the unit's display.
8.4 I/O
<M> Settings / General / I/O
Modules
Measurements
Control outputs
8.4.1 Modules
<M> Settings / General / I/O / Modules
ID
Status
Assign ID
Reset overload protection
VitaLite
66
To Next Page
Loading...
