<M> Settings / General / System configuration / Protected settings
Type of ballast
l Contact: A ballast that is controlled with a contact.
l MB-ZED: A ballast that is controlled via modbus type ZED.
l MB-PBF: A ballast that is controlled via modbus type PBF.
MB-
PBF
8.3 Communication
<M> Settings / General / Communication
Console settings
IO bus settings
Synopta settings
Network settings
Modbus Settings
8.3.1 Console settings
<M> Settings / General / Communication / Console settings
Delay time backlight off
This sets the duration that the display backlight will remain
on after pressing a button.
8.3.2 IO bus settings
<M> Settings / General / Communication / IO Bus settings
Delay module lost alarm
This sets the duration that the contact with an I/O may be
lost before an alarm is generated.
8.3.3 Synopta settings
<M> Settings / General / Communication / Synopta settings
Synopta address
Synopta port
Here you enter the port number of the Synopta service. This
value can be obtained from the Synopta server at:
http://localhost:64450/
Configure
Set this value to Yes to send the configuration data (modified
or otherwise) to the Synopta service.
VitaLite
65
To Next Page
Loading...
