<M> Settings / General / System configuration / Protected settings
2
nd
radiation sensor
l Yes: Activates a second radiation sensor for monitoring the
radiation measurements of the control sensor.
l No: No second radiation sensor is present.
T10 sensor
l Yes: Activates a T10 sensor. This sensor measures the UV
transmission rate through a 10-mm layer of water.
l No: No T10 sensor is present.
No
Disinfection capacity [m
3
/h]
Here you enter the disinfection capacity for which this unit was
designed.
Radiation dose [mJ/cm2]
Here you enter the radiation dose for which this unit was designed.
Design transmission [%]
Here you enter the UVc (short-wave UV transmission) rate of the
water for which this unit was designed.
Minimum design flow [m
3
/h]
Here you enter the minimum water flow rate for which the unit was
designed.
Maximum design flow [m
3
/h]
Here you enter the maximum water flow rate for which the unit was
designed.
Number of lamps in series
Here you enter the number of lamps installed in series.
Pre-blending control
This setting allows you to activate pre-blending control that
regulates the blending ratio between drain water and fresh water.
The pre-blending ratio is a fixed preset value or is calculated
depending on the volume of water in the drain tank and disinfected
tank. The pre-blending ratio can be influenced by the measured EC.
Filter flushing
l Yes: Filter flushing control is present.
l No: Control is not present.
Yes
Cleaning quartz tubes
l Yes: Control for cleaning the quartz tubes is present.
l No: Control is not present.
Yes
VitaLite
64
To Next Page
Loading...
