Figure 5-4: Post-flushing (with fresh water only)
5.3.2 Manually start cleaning quartz tubes
M Settings / Cleaning quartz tubes / Control / Manual control
Activate the VitaLite-E and C manually and check the following points:
Are all the valves working correctly?
Is the pump running? Is the flow rate sufficient?
Check the pH value during cleaning and post-flushing.
Make sure that the flow rate during the cleaning of the quartz tubes matches the
flow rate during normal operation in order to avoid unnecessary alarms.
Figure 5-5: Cleaning quartz tubes
VitaLite
46
To Next Page
Loading...
