6 Operation
As soon as the dealer has prepared the VitaLite-E and C for use, you can operate the
VitaLite-E and C.
This section first explains how to operate the power switch, the system pump and the
dosing pump. After that, you will find instructions on how to operate the VitaLite-E and
C. The three main processes are disinfection, filter flushing and cleaning the quartz
tubes.
6.1 Power switch
The power switch is located on the VitaLite cabinet.
Figure 6-1: The power switch
Operation:
Turn to position I (on) to switch the VitaLite on.
Turn to position 0 (off) to switch the VitaLite off.
The power switch can also be used as an emergency stop. Turn the switch to
the 0 (off) position to switch the VitaLite-E and C off immediately.
6.2 System pump and dosing pump
In addition to the system pump, the unit can be equipped with one or more dosing
pumps for adding acids or other chemicals to the water. The system pump and dosing
pumps also have a control knob on the front of the cabinet. The system pump has
three modes of operation: off, manually on and automatic.
VitaLite
50
To Next Page
Loading...