Message
Control pH too low (disinfection)
Check the relevant preset value and alarm threshold.
Check whether the dosing pump is operating correctly.
Check whether the pH sensor is dirty or needs replacing because it is too old.
If necessary, recalibrate the sensor.
Control pH too low (cleaning quartz tubes)
Check the relevant preset value and alarm threshold.
Check whether the dosing pump is operating correctly.
Check whether the pH sensor is dirty or needs replacing because it is too old.
If necessary, recalibrate the sensor.
Process computer offline
The process computer is switched off.
System restart after power failure, currently calculated values have been
erased
Internal controller malfunction or controller power failure.
The active processes have stopped.
The preset values have been erased.
All the settings will need to be re-entered after the controller has restarted
automatically.
System restart after power failure, settings saved
Internal controller malfunction or controller power failure.
The active processes have stopped.
The preset values are still present.
The next process start will be performed after the controller has restarted
automatically.
Filter contact sensor alarm
The system has either failed to receive measurement data from the sensor or
the measurement value is outside of sensor range.
Check the sensor and the sensor cable.
Valve contact sensor alarm
The system has either failed to receive measurement data from the sensor or the
measurement value is outside of sensor range.
Check the sensor and the sensor cable.
Lamp group contact sensor alarm
The system has either failed to receive measurement data from the sensor or the
measurement value is outside of sensor range.
Check the sensor and the sensor cable.
VitaLite
98
To Next Page
Loading...
