Publication 1734-UM001D-EN-P - April 2008
206 Configure POINT I/O Modules in RSLogix 5000 Software
5. Check the checkbox for the following, if desired:
• Disable All Alarms — A check in the checkbox tells the module to
not input alarms. This is disabled in Hard Run only.
• Latch Process Alarm — A check in the checkbox lets you latch
transient alarm conditions. This is disabled in Hard Run mode.
6. Click OK
Working with the Fault/Program Action Dialog
Use this dialog to configure and display the parameters controlling output
states during Fault and Program conditions. This dialog does not appear for
Listen Only connections. To complete the entries on the dialog, proceed as
follows.
1. From the top of the General dialog, click Fault/Program Action.
You see a Fault/Program Action dialog.
To Next Page
Loading...
Need help?
General
