V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Display
3.1.2 Display
In all operating modes the following receiver
settings are continuously displayed:
f Receive level, control voltage set (ma>
nually) indicated by the bargraph (resolu>
tion, see 3.1.18.15 for R&S EK 895 or
3.1.21.8 for R&S EK 896),
or
Frequency offset and / or frequency devia>
tion indicated by the bargraph with a res>
olution of 10 Hz or 100 Hz.
Note:
Switchover of the bargraph function is car>
ried out with key ENT and softkey IND. The
resolution depends on the set frequency
deviation (modulation modes FSK, AFSK
and F7B) or on the selected bandwidth
(modulation modes AM, CW, FM, FAX1
and FAX2).
f Frequency with a resolution of 1 Hz
f BFO frequency with a resolution of 10 Hz
f Bandwidth with a resolution of
100 Hz (R&S EK 895) or
1 Hz (R&S EK 895S7 and R&S EK 896)
f Channel
f Status for preamplifier (PREAMP), noise
blanker (NB), squelch (SQ), notch filter
(NOTCH), passband tuning (PB)
Except for entries, e.g. of a frequency, the fol>
lowing receiver settings are additionally in>
dicated:
f Modulation mode
f Type and time of control (SLOW, FAST)
f Current softkey assignment (menu line)
or
f Receive level (see 3.1.18.15 for R&S EK 895
or 3.1.21.8 for R&S EK 896)
f Current softkey assignment (menu line)
0
30
60
90
120
RF
dBoV
CHANNEL
BW
BFO
FREQUENCY
kHz
GAIN
MODULATION
FAST
Channel FrequencyBFO FrequencyBandwidthBargraph
PREAMP NB SQ NOTCH PBT
Status Line
Modulation
Mode
Control Type and Time
Current Softkey Assignment
(Menu Line)
e.g. R&S EK 896
6164.0717.02_01
> 3.3 >
To Next Page
Loading...
