V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Replacement of Modules
4.3.14 IF Processor R&S GM 893
Removal
1. Make preparations acc. to 4.3.1.
2. Pull off socket on RF cable W22 connected
to plug X95 (see Fig. 4.15).
3. Pull off socket on RF cable W24 connected
to plug X96.
4. Pull off socket on RF cable W25 connected
to plug X97.
5. Pull off socket on RF cable W23 connected
to plug X98.
6. Open grey extracting levers on IF processor
(see Fig. 4.12 (R&S EK 895) or Fig. 4.13 (R&S
EK!896)).
7. Pull IF processor completely out by taking
hold of the extracting levers.
Installation
Installation is to be carried out in the reverse
order of removal.
6164.0717.02_01
> 4.35 >
To Next Page
Loading...
