V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Installation into a 19" Rack
2.4.2.2 Installation of a Single Receiver R&S EK 895 with 19∫ Service Kit R&S ZZA>98
1. Make preparations acc. to 2.4.2.1.
2. If the service kit is to be fixed to the right>
hand side of the receiver:
On the right>hand side of the receiver
remove cover (5) and carrying handle (6).
If the service kit is to be fixed to the left>
hand side of the receiver:
On the left>hand side of the receiver
remove cover (5).
3. Connect front bracket (7) with two front
connecting elements (15) on left or right to
front frame by means of two screws (21)
and spring washers (27).
4. Fix front grip (14) and rack bracket (13) to
the other equipment side by means of two
screws (20) and toothed washers (26).
5. Fix rear bracket (10) to plate (11) by means
of two screws (22).
6. Fix plate (11) with screw (21), spring washer
(25), washer (27) and spacer (17) to rear of
frame.
7. Fix plate (11) with two screws (19), spring
washers (25) and washers (27) to rear panel
stand.
8. Fix lateral sheet (9), front bracket (7), front
grip (14) and rack bracket (13) to each
other by means of two screws (20) and
toothed washers (26).
9. Fix lateral sheet (9) to rear bracket (10) by
means of two screws (19) and spring wa>
shers (25).
10. Remove paper from adhesive layer and
affix guiding rails (16) to the bottom of the
receiver, previously cleaned with isopropyl
alcohol for example.
11. Secure the receiver to the rack by means of
four screws.
Fig. 2.3 19" Service Kit R&S ZZA>98
6164.0717.02_01
> 2.5 >
To Next Page
Loading...
