V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Installation into a 19" Rack
2.4.2.4 Installation of One Receiver R&S EK 896 with 19∫ Service Kit R&S ZZA>93
1. Remove spreaders in front stands (1) of re>
ceiver by means of screw driver for Phillips
screws.
2. Remove front stands of receiver.
3. Remove threaded studs in rear stands (2)
by means of Allan key.
4. Remove rear stands of receiver.
5. Remove all lateral stands (4).
6. Screw front grip (5) and rack bracket (6) by
means of two screws (7) and toothed wa>
shers (8) to right side of receiver.
7. Screw front grip and rack bracket by means
of two screws and toothed washers to left
side of receiver.
8. Remove paper from adhesive layer and
affix guiding rails (9) to the bottom of the
receiver, previously cleaned with isopropyl
alcohol for example.
9. Secure the receiver to the rack by means of
four screws.
Fig. 2.5 19" Service Kit R&S ZZA>93
6164.0717.02_01
> 2.7 >
To Next Page
Loading...
