V L F > H F R E C E I V E R S
f
R & S E K 8 9 5 / R & S E K 8 9 6
User Manual
f
Cabling
2.5 Cabling
(See also Appendix A2 as well as Figs. 2.27 and 2.28)
C A U T I O N
Before beginning the cabling make sure that the equipment has been switched off and is not
connected to the external mains.
AF
1/5/10 MHz
1. Connection of headphones
(R&S EK 896, rear)
Connect the jack>type socket to external
headphones.
As the mating contact we recommend the
use of a 6.3>mm plug (FT 019.0487).
Adjust the volume with the AF control on
the front panel, as required.
2. Connection of an antenna
Connect the recessed BNC socket via an RF
cable to an antenna.
As the mating contact we recommend a
straight BNC cable plug (FJ 075.8421). In
connection with the recommended
mating contact, the 75>] coaxial cable
(DH!025.2142) can be used.
3. Connection of an external frequency
standard
Connect the recessed BNC socket via an RF
cable to an external frequency standard
(1, 5 or 10 MHz).
Set the synthesizer for external synchroni>
zation and the required division ratio acc.
to Appendix A1.3.
As the mating contact we recommend a
straight BNC cable plug (FJ 075.8421). In
connection with the recommended
mating contact the 75>] coaxial cable
(DH!025.2142) can be used.
6164.0717.02_01
> 2.8 >
To Next Page
Loading...
